Top 8 Quartz Clock Movement Replacement – Wall Clocks

As an Amazon Associate I earn from qualifying purchases.

1. Pulsar

#ad

Seiko-SKP Quartz Clock Movement Kit with 5" Black Spade Hands for Dials up to 1/4"

#ad
Pulsar #ad - Clock movement quartz with Hands, Second Hand, and Wall Hanger. Threaded shaft length of 5/16", total shaft length of 5/8" Without Second Hand. Size: 2 1/8" Square. One set of hands & second hand included Minute hand measures 5" from mounting hole to tip. Max dial thinkness 1/4".
BrandPulsar #ad
ManufacturerSeiko-SKP #ad
Height8.2 Inches
Length2.4 Inches
Weight0.02 Pounds
Width1.6 Inches
Part NumberAX-AY-ABHI-78395
ModelAX-AY-ABHI-78395

2. Hicarer

#ad

Hicarer DIY Large Clock Hands 3D Wall Clock for Kitchen Office and Home Art Decor Quartz Clock Movement Mechanism Accessories

#ad
Hicarer #ad - Size: you can apply the clock movement kit to DIY a wall clock, and its mini size is approx. Material: the clock pointer is made of aluminum, please do not use too much pressure to avoid bending.

Center of hole hand size: the hour hand is approx. Kindly reminder: there is only one minute hand and one hour hand; After putting battery in, you must spend 5 minutes to test the clock move or not; Powered by 1 x 1. 5 v aa battery not included. Home decoration: you can diy a simple clock as wonderful decoration, then hang and stick it on the wall in bedroom, kitchen, living room or office.203 mm/ 8. 0 inches long; the minute hand is about 305 mm/ 12 inches in length; Second cap: approx. 70 cm/ 30 inch. 7 mm/ 03 inch,please check the size before purchase.
BrandHicarer #ad
ManufacturerHicarer #ad
Height0.79 Inches
Length16.73 Inches
Width3.94 Inches
Part NumberHicarer-Clock Movement-01

3. Dhorcas Designs

#ad

Gold, 1/2", 1/4" thread shaft, Dhorcas #014 with 1/4", 3/4" Threaded Motor and Long 12" Gold/Silver Hands, Quartz Clock Movement Kit for Replacement

#ad
Dhorcas Designs #ad - Please peel off protective plastic film from hands or you will think the hands are scratchy and not smooth. So make sure that your pivot hole in your dial is at least 3/8". In the case that you do, they may go bad, but as they are electronics, please reach out to us and let us know and we will replace it for you.

Please measure the thickness of your dial or the motor may not work for your project. Please note also that the holes in these hands are fully round and not rectangular, and they only work with push-on hands type motors. Can be cut with any household scissors.

We stand behind the quality of our motors, or you may receive a defective motor. Works with dials up to 3/16" thick. This kit does not include a hanger. Motor size: 2 2/16" x 2 2/16" x 5/8". This threaded shaft is 1/4", and the Total shaft length is 1/2". Motor is mute/quiet, smooth sweep motion, no tick tock. The hands are light metal. The threaded shaft diameter is 1/4".
BrandDhorcas Designs #ad
ManufacturerQuartz #ad
Height2 Inches
Length12 Inches
Width2 Inches
Part Number6262

4. Pulsar

#ad

Seiko-SKP Quartz Clock Mechanism Movement Kit with 5 1/4" Black Spade Hands for Dials up to 1/2"

#ad
Pulsar #ad - Size: 2 7/32 Square. Max dial thinkness 1/2". Clock movement quartz with Hands, Second Hand, and Wall Hanger. One set of hands & second hand included Minute hand measures 5 1/4" from mounting hole to tip. Threaded shaft length of 9/16", total shaft length of 7/8" Without Second Hand.
BrandPulsar #ad
ManufacturerSeiko-SKP #ad
Height8.5 Inches
Length3 Inches
Weight0.1 Pounds
Width2 Inches
Part Numberna
ModelAX-AY-ABHI-69089

5. Seiko

#ad

Seiko 28909V Quartz Clock Movement for up to 1/8 inch Clock face Thickness

#ad
Seiko #ad - The movement case is approximately 2-1/8”x 2-1/8” x 1/2”. Not included. Uses "aa" battery. 28909v 3/16" threaded shaft length, 1/2" Total shaft length. Authentic seiko brand clock movement, marked as SKP SEIKO Precision Inc. On the backside. Includes a pair of black spade 2-1/2" hour and minutes hands, a red 2-3/4" second hand, and mounting hardware.
BrandSeiko #ad
ManufacturerSeiko Precision Inc. #ad

6. Unknown

#ad

12888 quartz clock movement, Factory model 12888S

#ad
Unknown #ad - Movement housing is 2-3/16" x 2-3/16" x 5/8. Hour:. 2" 5 mm minute:. 125" 3. 2 mm. Total shaft length is 9/16" 14. 75mm ► uses one "AA" battery not included. Threaded portion is 5/16" diameter and 1/4" 7mm long. Youngtown puts the number 12888 on nearly everything they make so be sure to check the following dimensions:. Diameters of hand shaft mounts are the most popular.
BrandUnknown #ad
ManufacturerNA #ad

7. EMOON

#ad

EMOON 2 Pair Hands 3D Clock Movement DIY Large Wall Clock Quartz Clock Mechanism for Home Art Decor Black

#ad
EMOON #ad - Fit clock over 20 in diameter: the hour hand of tyle1 is approx. And the clock part is delicate, please do not use too much pressure. 7. 1 in; minute hand is approx. Time-keeping and sweep movement motor: features High Torque Quartz Clock Mechanism, ensures watchmaker's accuracy; silent movement; powered by a AA battery, easy hang up on the nail included.

9. 1 in; style 2: the hour hand is approx. Diy clock kit: ornate set with 2 pairs of different style clock hands for your options, minimalist wall clock as a gift, frameless theme clock, create your own DIY craft clock, and family photo wall clock.66. 5 in; minute hand is approx.

A winning combo of quality and classic: comes with a high precision sophisticated clock movement, 1 brushed nickel finish clock dial, keep accurate time for years; 2 pairs of Aluminum clock hands, bring sleek and modern to your room. Easy to assemble: the clock dial is pre-installed, we only need to assemble all clock hands in place and parallel. 9. 6 in, creating your own clock.
BrandEMOON #ad
ManufacturerEMOON #ad

8. dailymall

#ad

Gold, dailymall Clock Inserts, Round Clock Inserts Recessed Quartz Clockwork Table Clock Clock Movement Clock DIY Diameter 70mm

#ad
dailymall #ad - Dimension: front dia: 70mm, back dia: 61mm, back diaincluding gasket: 61mm, Plastic Clock Dia: 70mm; Golden Frame Dia: 70mm, inserted depth: 17mm, total thickness: 29mm, Thickness: 30mm. Quartz clock insert features a gold colored trim, and black Arabic numerals on dial for easy reading. Material: pvc clock face, aluminum clock hand, black hour minute and second hands. Great for diy crafts or replacing old clock faces, and the clear cover reads the time easily. Come with back cover and rubber gasket to securely hold the insert in place, which can avoid slight irregularity in the hole.
Branddailymall #ad
Manufacturerdailymall #ad
Part Number4c1b61351a2145e866eeddd27799d1af